A. Charcoal Grill (BZ5S)  B. Rotisserie Kit (BZ5S)  C. Auto Flip Skewers (Z5)

INSTALLATION STEPS

For Charcoal grill
Foot installation method 1
Use wing nut to install, you can adjust the appropriate height arbitrarily, tighten the wing nut to fix the foot.

Foot installation method 2

No wing nut is required for installation, only one height, Just tighten the feet directly.
So easy.

For Auto Flip skewers

Step1

Insert one of the threaded ends of the guide rod into any square hole on the back of the main engine unit as shown in the figure, and pass the round hole on the front.

Step2

Screw the wing nut clockwise to the thread of the guide rod, do not tighten it.

Step3

Install another guide rod in the other hole in the same way.

The other two guide rods are screwed clockwise to the other end of the installed guide rods as shown in the figure.

NORMAL MISALIGNMENT

NOTE:Thread processing needs to have a certain clearance, so it is difficult to have the same plane after the guide rod is tightened, and there will be a normal misalignment. At this time, you only need to loosen the guide rod a little, Make sure that the surfaces of the two guide rods are flush.

Step4

Pass the Skewer support frame and the Fixed frame through the guide rods in sequence as shown. Place the large end of the Fixed frame close to the charcoal grill while passing through the guides rod. Place the installed Auto Flip skewers on the charcoal grill.

Step5

Fix it on the charcoal grill body with 2 wing screws.

Step6

Adjust the position of the Skewer support frame and the Fixed frame according to the length of the skewers to ensure that the effective part of the skewers is above the fire in the charcoal grill and the other end of the skewers is in the slot of the Skewer support frame.

Step7

Step8

Refer to motor installation instructions（Click the picture below）。

Step9

The installation is complete.

AUTO FLIP SKEWER MAINTENANCE

The Auto Flip Skewer is driven by a chain. After use, please wipe it clean and dry it and store it in a dry place. If possible, add chain oil to it to prevent the chain from rusting for a long time and cause transmission difficulties.

For Electric Rotisserie

Step1
Fix the support plate to the side plate of the Charcoal grill body with wing screws.
Note: The support plate is the same on both sides of the Charcoal grill body and cannot be installed in reverse.

Step2
Turn the Extension rod (B5) clockwise to the Rotating rod(B4), do not tighten, Screw the Nylon Handle(B6) to the Extension rod (B5) in the same way and tighten it.

Step3

The forks through the rod, screw the thumb screws to the forks. After loading the food, adjust it to the proper position and tighten the thumb screws.

NORMAL MISALIGNMENT

NOTE:Thread processing needs to have a certain clearance, so it is difficult to have the same plane after the guide rod is tightened, and there will be a normal misalignment. At this time, you only need to loosen the guide rod a little, Make sure that the surfaces of the two guide rods are flush.

Step4

Place it in the proper height on the support plate to rotate.

Step5
Refer to motor installation instructions.
The installation is complete.

MOTHER CLIP INSTALLATION

(Some models are mother clip or later customers purchase mother clip separately)

Before using for the first time, adjust the mother clip according to the size of your own bamboo skewers or other baking needles to be clamped (mother clip chuck fixed rotating handle or handle fixed rotating mother clip chuck). In the later use, just turn it clockwise to tighten it, and turn it counterclockwise to loosen it.

Note: Please wear BBQ Anti-scalding gloves when loading and unloading the baking needles